GENTLEMONKEYS MONKEY 20 SET

1 CLEAN

Clean dirty surfaces with a wet wipe – without any pressure, one area at a time – in linear movements.

It should noted that the wipes are fresh out of pack and has enough liquid and not dry. If you notice that a wipe is already a bit dry or very dirty, use a fresh cleaning wipe. In this step, any dirt (even dried or stubborn particles) is gently absorbed.

 

2 PRE-POLISHING

Pre-polish with the short-pile side of the microfiber cloth in linear movements and only light pressure. The liquid on the surface must then be treated immediately and must not dry out.

 

3 POLISHING & SEALING

Polish and seal shiny with the long-pile side of the microfiber cloth in circular motions

 

COARSE SOILING SUCH AS SAND, MUD, ETC. MUST BE REMOVED IN ADVANCE BY CONVENTIONAL PRE-WASHING. 

DO NOT USE ON HEATED SURFACES OR IN DIRECT SUNLIGHT.

 

The cleaning performance of the wet wipes is strong that simple paint care products used earlier are removed from the surface. Underneath, the actual paint pattern comes to light, which can appear stained in some cases. This is not damage to the paint caused by the GentleMonkeys wet wipes. If in doubt, first test on small surface.

 

CAN I TREAT MATT SURFACE?

The company has extensively tested the wet wipes on an enormous number of paints. In principle, the wipes also work perfectly on matt lacquers – please note, however, that you should at best test in an inconspicuous place beforehand. And of course, it is important to apply evenly and polish before the liquid on the surface dries in order to avoid cloud formation.

By gently applying (without pressure and in linear movements) the emulsion of the wet wipes to the surface to be cleaned, dust and dirt particles are first dissolved and coated with a protective layer. At the same time, the surface to be cleaned is protected by special contents of the emulsion. The result is a double shell between surface and dirt. Subsequently, the dirt is gently removed with the specially adapted microfiber cloth. By polishing the surfaces (with the long-pile side of the microfaster cloth) you give your vehicle enormous shine. The special formulation of the wet wipes leaves a wafer-thin polymer layer. In combination with oxygen, this hardens and protects the treated surface sustainably against environmental influences such as UV rays, water or similar.

 

The company has extensively tested the wet wipes on an enormous number of paints. In principle, the cloths also work perfectly on matt lacquers – please note, however, that you should at best test in an inconspicuous place beforehand. And of course, it is important to apply evenly and polish in order to avoid cloud formation.

Click the link to download the product sheet.

 

GM-ProductSheet-EN-OP.pdf (gentlemonkeys.com)